| |
Wiring Caution!
Connect the cable to the connector on the body
with the wiring arranged as show below. Proceed carefully,
as incorrect wiring can cause damage.
Further, use DC power with sufficient capacity and a low ripple.
 |
Current signal type
Voltage signal type |
Preset input type |
| 1 |
Brown |
Power supply |
| 2 |
White |
Input signal |
| 3 |
Blue |
GND (Common) |
| 4 |
Black |
Monitor Output |
|
| 1 |
Brown |
Power supply |
| 2 |
White |
Input signal 1 |
| 3 |
Blue |
GND (Common) |
| 4 |
Black |
Input signal 2 |
|
Note: A
right angle type cable is also available. The entry direction
for the right angle type connector is to the left, (support
side.) Never turn the connector, as it is not designed
to turn.
Wiring
Diagram
| Current signal type |
Voltage signal type |
 |
Vs: Power supply = 24VDC
A: Input signal = 4 to 20mADC |
Vs: Power supply = 24VDC
Vin: Input signal = 0 to 5VDC |
Preset input type
Vs: Power supply = 24VDC
Note: One
of the preset pressures P1 through P4 is selected by
the ON/OFF combination of S1 and S2.
| S1 |
OFF |
ON |
OFF |
ON |
| S2 |
OFF |
OFF |
ON |
ON |
| Preset
pressure |
P1 |
P2 |
P3 |
P4 |
Note: *For
safety reasons, it is recommended that one of the preset
pressures be set to OMPa. |
|
