DRIVE BOARDS AND ACCESSORIES

 

DRIVE BOARDS AND ACCESSORIES
EVB-5000 Evaluation Board
The EVB-5000 Evaluation Board is a development tool designed to allow fast and inexpensive evaluation of Airtrol's SDU-5000 series Stepper Motor Driven Regulators. When used in conjunction with the calibration data included with every SDU-5000, the EVB-5000 can be used to confirm repeatability, step rate, linearity, etc., of the regulator. The EVB-5000 features an on board clock and counter, and can be configured to run the SDU-5000 from 8 to 8184 steps. The EVB-5000 is also capable of accepting external control inputs, to assist in developing software and feedback loops. This feature also allows the EVB-5000 to be used in simple stand alone control applications where sophisticated electronics are not available.

SPECIFICATIONS
SUPPLY VOLTAGE 12 VDC
SUPPLY CURRENT Min. 400 mA
SELECTABLE STEP RANGE 8 - 8148 steps
STEP RATE 225 PPS

ORDERING INFORMATION
PART NUMBER DESCRIPTION
EVB-5000 Evaluation Board
SDB-5000 Stepper Motor Drive Board
The SDB-5000 drive board fits neatly inside Airtol's SDU-5000 Stepper Drive Unit. Designed for OEM applications, the L/R drive configuration provides reliable performance at an economical price. The control interface is greatly simplified, requiring only TTL inputs for direction and clock. Also available are a 1 ft. and 3ft. interface harness, and connectors to allow assembly of OEM wiring harnesses. Units ordered with a drive board and wiring harness will be shipped fully assembled.

SPECIFICATIONS
INPUTS  
VCC 5 - 12 VDC
Vm 12 VDC
DIR TTL, DTL, MOS Compatible
Low (0) = Decrease
High (1) = Increase
CLK TTL, DTL, MOS Compatible
225 Hz Fixed frequency
Positive Edge Triggered

OUTPUTS  
1 MOTOR 170 mA/coil @ 12 VDC,
36 ohms/coil
STEP RATE Motor step rate = Clock Freq.

ORDERING INFORMATION
PART NUMBER DESCRIPTION
SDB-5000 12 Volt Drive Board
SDH-1 Interface Harness, 1ft.
SDH-3 Interface Harness, 3ft.
SDH-4 4 Pin IDC Connector (Motor)
SDH-5 5 Pin IDC Connector (Interface)